x. Disable fillament sensor before loading
x. Load manually through idler door and use PLA with move E steps to load fillament (go slowly)
x. Start print immediately after that (?)
x. Use textured sheet (no glue/spray needed)
x. Avoid crossing perimeters : on
x. Ambient 15-30 deg, i.e. enclosure door opened
x. scarf joints work a bit questionable
x. "Outer perimeter first" not tested, but it does not work well for other flexibles
x. Tested only with 0.4 copper nozzle with 0.2 layer
x. Print from dry-box @ 50 deg
x. seams "nearest"
x. In print preparation keep head clean with plyers till print starts
x. Use skirt at least 20 cm